!Runun6>)E/\ |@HL6e@y#Đ7c޸ILC;1\"F#eĀ#G )S'sHTȯÈVjdI  9e1e :b,Q@J"nA 2ebؘ M C'Q F^Qj֭ ԪZnᖑK.ޯiŪ79w^mܹu^= A3010 oder mit Video-Enhancer... Viel Spa! CocoVGA ist FREEWARE, d.h. es darf ohne Vernderungen frei kopiert werden. Alle Rechte liegen beim Autor. CocoVGA wurde mit Coconizer V1.31 getestet. Ob neuere Versionen auch funktionieren kann nicht garantiert werden... ...just try! Bei Fragen und Anregungen sowie Spenden: Andreas Schubert Herbert-Wehner-Str. 42 D-90427 Nrnberg 0911/3071631 email: platon@cip1.e-technik.uni-erlangen.de (bis September 1994)Mode124@>[@EjZ \4<XCVDULMode124Mode124 1.24 (30 Jan 1994)O-< c 倏h 倏O-\ P10 F1 O-Pu' 5 PVIDCEnhancer0VIDCEnhancer1-`V7 ' UH@@@0 0@#2 VlObOAlias$VIDCEnhancer0O-Pu 5 P P@0@-1d |00 H @-1( D @000#  5Philips CM8873$ |T@ @x@yc@@MM+K _#    ReadMeH[-aE?V$Helpfile for CocoVGA 1994 by Andreas Schubert What does CocoVGA? CocoVGA is a little improvement that enables you to use Coconizer with VGA- and MultiSync-monitors that sync at 30kHz. What to do? Rename the old !Run (e.g. to !Run1) and replace it with the new one. Then copy the modules CocoVGA and Mode124 into the !Coconizer directory, too. That's all... How does it work? You have to start Coconizer as usual. With the two function keys F1 and F2 you could switch between the original mode and the new one that VGA monitors are able to display. You have to remember that you have to wait after a mode change untill the screen is refreshed, otherwise you risk a system breakdown! If you want to work with Coconizer (load songs, edit, ...) you have to use the new mode (F2) and if you want to play the song, use the old mode (F1) because the player isn't able to play songs in correct speed with the new mode. I suggest to set the screenblanker's time to 30 sec. to blank the screen after a short time when playing to stop the "strange" display... If you leave Coconizer's desktop the palette has been modified, so you have to restore it (e.g. with default in the palette menu). You also avoid pressing F1/F2 within the wimp... (normaly nothing strange happens except a mode change, but murphy is everywhere!) Quitting Coconizer deletes all modules and F1/F2 can be used normaly. Oh, all only works with an archi >= A3010 or a video enhancer... Have a lot of fun! CocoVGA is freeware and may be copied free without any changes. All rights reserved. CocoVGA was tested with Coconizer V1.31. If any newer version works with it could not bee guaranteed... ...just try! For any questions and suggestions or donations: Andreas Schubert Herbert-Wehner-Str. 42 D-90427 Nrnberg Germany 0911/3071631 email: platon@cip1.e-technik.uni-erlangen.de (untill september 1994)