Remember to use the right port settings. This software works with the cable
described in the BUPS-HOWTO (see sunsite.unc.edu:/pub/Linux/docs/HOWTO).

The file ACTIVE in the power directory indicates that the rc script should
run this daemon (I have another powerdaemon somewhere. This was my way of
easily switching between the two on boot up).

Use the rc file to start the software, and customize to your settings.

My Port settings:

speed 9600 baud; rows 0; columns 0; line = 0;
intr = ^C; quit = ^\; erase = ^?; kill = ^U; eof = ^D; eol = <undef>;
eol2 = <undef>; start = ^Q; stop = ^S; susp = ^Z; rprnt = ^R; werase = ^W;
lnext = ^V; flush = ^O; min = 1; time = 0;
-parenb -parodd cs8 hupcl -cstopb cread clocal -crtscts
-ignbrk -brkint -ignpar -parmrk -inpck -istrip -inlcr -igncr icrnl ixon -ixoff
-iuclc -ixany -imaxbel
opost -olcuc -ocrnl onlcr -onocr -onlret -ofill -ofdel nl0 cr0 tab0 bs0 vt0 ff0
isig icanon iexten echo echoe echok -echonl -noflsh -xcase -tostop -echoprt
echoctl echoke

Important settings:
	clocal -crtscts

jan vilhuber
vilhuber@cs.colorado.edu
